|
Engine change, Jdm into uk model 6 Years, 4 Months ago
|
Karma: 0
|
|
I have a 1995 MR2 Rev3 with a blown engine (4 years of tracking and being double driven so very forgiveable) I can get a 1997 3SGE JDM engine , will it just plug in or does it need anything done.
|
|
jcmr2
Fresh Boarder
Posts: 16
|
|
|
|
|
Re: Engine change, Jdm into uk model 6 Years, 4 Months ago
|
Karma: 328
|
|
Don't think it will as the 1997 would most likely be a rev 4. They came equipped with additional EGR gubbins. Therefore it very likely that the ECU pins are different to run the engine correctly.
|
|
|
|
"Happier than a tornado in a trailer park"
"Just as in cuisine, the ‘flavor’ of a car is quite important…”
Hiromu Naruse 1943-2010 RIP |
|
|
Re: Engine change, Jdm into uk model 6 Years, 4 Months ago
|
Karma: 0
|
|
There is no Egr on it, i dont think Jap imports had egr, someone said they are designed to run on 98 octane fuel.
|
|
jcmr2
Fresh Boarder
Posts: 16
|
|
|
|
|
Re: Engine change, Jdm into uk model 6 Years, 4 Months ago
|
Karma: 72
|
|
If they are both rev3 NA and look identical then its a plug and play job.
Have you pics of both engines?
|
|
|
|
|
|
|
Re: Engine change, Jdm into uk model 6 Years, 4 Months ago
|
Karma: 0
|
|
They look identical
|
|
jcmr2
Fresh Boarder
Posts: 16
|
|
|
|
|
Re: Engine change, Jdm into uk model 6 Years, 4 Months ago
|
Karma: 72
|
|
throw the engine loom over so its a plug and play job, in the unlikely case a sensor or 2 are different just use the ones from the blown engine
|
|
|
|
|
|
|
