Welcome, Guest
Please Login or Register.    Lost Password?

Howtwo: Pair an Mk2 MR2 Alarm Fob (Factory)
(1 viewing) (1) Guest
Go to bottomPage: 1
TOPIC: Howtwo: Pair an Mk2 MR2 Alarm Fob (Factory)
#34393
Howtwo: Pair an Mk2 MR2 Alarm Fob (Factory) 5 Years, 7 Months ago Karma: 106
MODS: Feel free to edit or remove this as you feel fit - I will however say theres way easier ways of disabling a Toyota alarm then the steps below with less hassle and the fact that this does NOT remove the transponder key out of the equation means your car is still safe..besides you need the cars key to do this!! ...just my caveat!

Well guys I got the car with only one fob which is feckin pain...but as luck would have it theres plenty of these fobs going around for buttons on eBay, scrappies, etc. This guide is for a Mk2 MR2 Rev 5 (2000) but should be the same for all mk2s..I feel a picture says a thousand words so I hope this helps at least one of ye!

I myself picked up a brandnew fob in Toyota bubblewrap for £7 sterling delivered off eBay.

Now the tricky part making it work with your car!

1) Get a fob - doesn't matter if its been used before - Part No for my TVSS IIIB fob is 08191-00880


_KUNENA_BBCODE_HIDEIMG


2) Take off trim around radio and heater (see fitting radio guides for this)

3) Remove screws on heater assembley and tie it up around radio area (you may need to unplug cables)


_KUNENA_BBCODE_HIDEIMG


4) In the wiring guide it mentions the TVSS ECU is located behind the trim behind the drivers seat (under seatbelt) however while fitting a new radio I noticed the ECU behind the heater assembly so decided to kill 2 birds...


_KUNENA_BBCODE_HIDEIMG



_KUNENA_BBCODE_HIDEIMG


5) Pull with a bit of force to remove the ECU from its place (its stuck down)


_KUNENA_BBCODE_HIDEIMG


6) Remove philips screw and revit from protective plate..my cordless drill batteries are fucked and as it was wet today I didn't fancy running a lead out to the car!


_KUNENA_BBCODE_HIDEIMG



_KUNENA_BBCODE_HIDEIMG



_KUNENA_BBCODE_HIDEIMG


7) Pull the Protective Plate up


_KUNENA_BBCODE_HIDEIMG


8) Pull back the foam cover


_KUNENA_BBCODE_HIDEIMG


9) Put your ignition to ACC


_KUNENA_BBCODE_HIDEIMG


10) Time to pair the fob - hold the green button on the ECU in for more then 2 seconds until the security light stays solid then release (times out after 5 seconds)


_KUNENA_BBCODE_HIDEIMG



_KUNENA_BBCODE_HIDEIMG


11) Within 5 seconds (while security lights solid) hold down the 2 buttons on the fob until the indicator lights flash


_KUNENA_BBCODE_HIDEIMG


Test your fob locks / unlocks car. Your done..:D

NOTE: You can only pair 4 fobs to the one car! The Last 4 paired fobs will be the only active ones.

12) Reverse actions as before, re-rivet the TVSS ECU if need be.



ATTACHED is the part of the TVSS IIB manual...helped me alot with this!

EDIT: Couldn't attach but manual is here: http://www.toyota-tech.eu/legacy/Toy/aimuploads/%7B4CD304D2-A41B-91D3-284C-8CC4FE5FA41B%7D/Celica_TVSSIIIB.pdf
eringobragh
Addict
Posts: 1646
graphgraph
User Offline Click here to see the profile of this user
Location: Dublin
Last Edit: 2011/08/27 19:14 By eringobragh.
Comments? Suggestions? Register above to have your say!
 
#34403
Re: Howtwo: Pair an Mk2 MR2 Alarm Fob (Factory) 5 Years, 7 Months ago Karma: 326
A worthy addition to the How Two's, Kc'd and thanks.
slipsliderg
"if it ain't broke don't fix it"
Moderator
Posts: 3963
graphgraph
User Offline Click here to see the profile of this user
Gender: Male Location: Meath Birthday: 04/26
"Happier than a tornado in a trailer park"

"Just as in cuisine, the ‘flavor’ of a car is quite important…”
Hiromu Naruse 1943-2010 RIP
Comments? Suggestions? Register above to have your say!
 
#34404
Re: Howtwo: Pair an Mk2 MR2 Alarm Fob (Factory) 5 Years, 7 Months ago Karma: 154
A KC is deserved just for your key chain, never mind the how to lol

KC+1
Infamous
Petrol Head <(+_+)>
Addict
Posts: 2150
graphgraph
User Offline Click here to see the profile of this user
Gender: Male Location: Derry/Donegal Birthday: 04/22
Comments? Suggestions? Register above to have your say!
 
#34423
Re: Howtwo: Pair an Mk2 MR2 Alarm Fob (Factory) 5 Years, 7 Months ago Karma: 106
Infamous wrote:
A KC is deserved just for your key chain, never mind the how to lol

KC+1


Haha cheers
eringobragh
Addict
Posts: 1646
graphgraph
User Offline Click here to see the profile of this user
Location: Dublin
Comments? Suggestions? Register above to have your say!
 
Go to topPage: 1